|
 |
|
|
Galoþ Mat
FAQ
Products Page |
|
How to wear an overshoe?
Open the top cover by pushing the handles on both sides of the upper cover. Using the setting arm provided with the Galosmat, push the connection latches of the over pin cover forward, to open the covers on both sides. Using the same arm, press the pins downwards, then turn them sidewise to lock in the housing. Insert the overshoes in the bunches through these pins from their rings. Do not forget to open the packing. Thoroughly spread the overshoes with your hand so that the machine will operate problem free. Repeat this procedure in every bunch insert (you can insert maximum 4 bunches, 1 bunch contains 10 units, there should be 40 overshoes in total.) When the overshoe inserting is complete, close the covers on the pin. Ensure that the connection latches are in straight position. Press the over pin covers so that they are thoroughly locked. Set the upper cover in place, lock the handles on both sides. Before using Galosmat, press once with your foot hardly so that it comes just in the middle of the pedal.
------------- |
|
How to use Galosmat ?
There is a pedal system in the middle part of Galosmat. Just press once onto this by applying
your body weight to wear overshoes.
|
|
-------------
What if I do not apply a balanced weight while using Galosmat?
Galosmat’s working principle is proportional to balance. If foot is pressed without balance, the overshoe rings at the section where there is less pressure, would not be released by the pins of the machine, yielding a failure.
------------- |
|
What can I do if some of the overshoe rings are not released from the pins?
Stop using the machine. Try to release the overshoe ring connection by mildly pulling with your hand, but be careful while doing this, because the ring may stay on the machine, detaching off the overshoe. |
|
-------------
What can I do if the overshoe ring breaks and remains on the machine?
In such a case, do not use the machine, because it will
operate in an unbalanced manner. Immediately open the
upper cover and press tightly with your hands on the
overshoes where the ring remains trapped. On the other
side, open the overpin cover, using your hand. The
broken ring will be seen fixed on the pin. Remove the
ring manually and close the overpin cover again. |
|
|
|
